Views: 0 Author: Site Editor Publish Time: 2026-11-18 Origin: Site
The hydraulic system acts as the core actuator of rotary drilling rigs. Weak movement, jitter, abnormal noise or leakage of the main winch, rotary head and luffing cylinders are mostly caused by hydraulic circuit faults. Start troubleshooting by checking pressure gauge readings to tell whether insufficient pressure comes from the main pump or pressure loss due to internal leakage of valve groups and motors. Meanwhile, check the hydraulic oil level, oil color and filter element condition. Emulsified or contaminated oil will accelerate valve wear and lead to jerky movements. Leakage at pipe joints and seals should never be overlooked, as minor leaks will gradually cause pressure drop of the whole machine. After confirming normal pressure readings, check for stuck relief valves and counterbalance valves to avoid blind disassembly, locate faults rapidly and ensure continuous boring operations.
Electrical faults often show as dashboard alarms, unresponsive buttons and failed action commands, which are easily misjudged on site. Start with basic power supply, checking battery voltage and loose, oxidized or burnt main harness connectors. Loose terminals frequently occur under vibrating working conditions. Then read controller fault codes and check sensors, limit switches and communication lines along signal circuits. Abnormal signals of rotary head speed and depth sensors will directly interfere with drilling parameter control. Damaged harness sheath and failed shielding cause signal interference and intermittent alarms. Sort out power supply, sensing and communication lines to quickly distinguish component damage from wiring faults and cut downtime.
As the power source of the machine, the engine usually fails with insufficient power, black smoke, abnormal noise and overheating shutdown. First inspect the fuel supply chain. Clogged filters and accumulated water in fuel-water separators restrict fuel supply and lead to obvious speed drop under load. Clogged air filters and intercooler leakage on the air intake side result in incomplete combustion and black smoke. The heat dissipation system is critical for heavy-load construction in summer. Blocked radiators, stuck thermostats and faulty fan drives easily trigger overheating protection and torque limitation. Keep an eye on engine oil pressure and exhaust sound to detect hidden troubles of turbochargers and valve mechanisms early and prevent minor faults from developing into severe engine damage.
Many shutdown failures do not stem from a single system but result from coupling among hydraulic, electrical and power systems. For instance, excessive engine load may be caused by abnormal signals of the hydraulic pump regulator that keeps large displacement output. False electrical alarms can also activate power limiting protection and make the whole machine underpowered. Faced with such composite symptoms, do not repair only one system. Read electronic control data and observe load curves to check whether instruction signals match actual execution. Understand the interlock protection logic between systems to avoid repeated part replacement without solving faults and improve on-site maintenance efficiency.
The essence of rapid diagnosis is early fault identification. Conduct pre-shift inspections to check hydraulic oil condition, tightness of electrical connectors, oil and water indicators of the power system, and keep components clean and dust-free. After intensive drilling operations, recheck seals, sensors and heat dissipation assemblies. Accumulate maintenance experience based on fault codes and working parameters to form on-site prediction habits and reduce unexpected shutdowns. Stable equipment performance guarantees the construction schedule of pile foundation projects and cuts maintenance costs.